Zhuoxin

24V proximity switch EI2Y30BS10PAW2HH is mainly used for proximity switches, which are widely used in Hangkong, Hangtian technology, and industry. In daily life, such as hotels, restaurants, and garages, automatic doors and automatic hot air fans are all used. In terms of anti theft, important places such as data archives, finance and accounting, museums, and vaults are usually equipped with anti-theft devices composed of various proximity switches. In measurement techniques, such as length and position measurement; In control technology, such as displacement, velocity, and acceleration measurement and control, a large number of proximity switches are also used< Technical parameters: 1. Body material: A B.S2、 Filler: Epoxy3, high-power: 10W4, large switching voltage: 100 VDC5, large switching current: 0.6, small breakdown voltage: 220 VDC7, large load current: 1.0A8, large grounding resistance: 100 mΩ 9. Small insulation resistance: 108Ω 10. Release time: 0.1 ms Max11, induction time: 0.4 ms Max detection: 2.1. Action distance measurement; When the action piece approaches the sensing surface of the proximity switch from the front, the distance of the proximity switch action should be the maximum action distance of the proximity switch, and the measured data should be within the product's parameter range. 2.2. Determination of release distance; When the action piece moves away from the sensing surface of the proximity switch from the front, and the switch switches from action to release, measure the distance the action piece moves away from the sensing surface. 2.3. Determination of return error H; The difference between the distance of major movements and the distance of release. 2.4. Measurement of action frequency; Use a speed regulating motor to drive a rubber disc, fix several steel plates on the disc, adjust the distance between the switch sensing surface and the action plate to about 80% of the switch action distance, rotate the disc, and sequentially make the action plate close to the switch. A speed measuring device is installed on the disc spindle, and the switch output signal is connected to the digital frequency meter through Zhengxing. At this point, start the motor and gradually increase the speed. Under the condition that the product of the speed and the action piece is equal to the frequency count, the action frequency of the switch can be directly read out by the frequency meter. 2.5. Determination of repeatability; Fix the action piece on the quantity, and control the movement speed at 0.1mm/s from the front of the switch sensing surface near the action area of the switch, beyond 120% of the switch action distance. When the switch is activated, read the reading on the quantity and then exit the action area to disconnect the switch. Repeat this process 10 times, and then calculate the difference between the large and small values of the 10 measurements and the average of the 10 measurements. The larger difference is the repeatability error. 24V proximity switch EI2Y30BS10PAW2HH;