Zhuoxin

IN8-M18-M4/2M Proximity Switch Wiring Product Description: In general industrial settings, eddy current and capacitive proximity switches are commonly used. Because these two types of proximity switches have higher environmental requirements. When the tested object is a conductive object or an object that can be fixed on a metal object, eddy current proximity switches are generally chosen because of their response frequency, good resistance to environmental interference, wide application range, and wide range. If the measured object is non-metallic (or metallic), liquid level, powdery substance, plastic, etc. A capacitive proximity switch should be selected. This type of switch has a response frequency but good stability. Environmental factors should be considered during installation. If the measured object is a magnetic material or if magnetic steel is buried inside the measured object to distinguish it from objects moving together, a Hall proximity switch should be used. IN8-M18-M4/2M proximity switch wiring 1) There is a difference between two wire and three wire proximity switches. Three wire proximity switches are further divided into NPN and PNP types, and their wiring is different. 2) The wiring of the two wire proximity switch is relatively simple. The proximity switch is connected in series with the load and then connected to the power supply. 3) Wiring of the three wire proximity switch: connect the red (brown) wire to the positive end of the power supply; Connect the blue wire to the 0V end of the power supply; The yellow (black) line represents the signal and should be connected to the load. The other end of the load is connected as follows: for NPN type proximity switches, they should be connected to the positive end of the power supply; For PNP type proximity switches, they should be connected to the 0V end of the power supply. 4) The load of proximity switches can be signal lights, relay coils, or digital input modules of programmable logic controllers (PLCs). 5) Special attention should be paid to the type selection of the three wire proximity switch connected to the PLC digital input module. PLC digital input modules can generally be divided into two types: one type has a common input terminal that is the negative pole of the power supply, and the current flows out from the input module. In this case, NPN type proximity switches must be selected; Another type of common input terminal is the positive pole of the power supply, and the current flows into the input module. At this time, it is necessary to choose a PNP type proximity switch. Don't make the wrong choice. 6) The two wire proximity switch is limited by working conditions, and when conducting, the switch itself generates a certain voltage drop. When cutting off, there is also a certain amount of residual current flowing through. Therefore, consideration should be given when selecting it. Although the three wire proximity switch has an additional wire, it is not affected by adverse factors such as residual current and works more reliably. 7) Some manufacturers will approach the switch's&quo; Normally open; And&quo; Normally Closed; If the signal is simultaneously led out or other functions are added, please wire according to the product manual& nbsp; Commonly used proximity switch NCN15-30GM40 NO;