Zhuoxin

Shandong Zhuoxin Machinery Co., Ltd. NBB4-12M-E2-V1 Proximity Switch Selection Techniques Shandong Zhuoxin NBB4-12M-E2-V1 Proximity Switch Selection Techniques Proximity switches, also known as proximity sensors, cover the needs of mechanical instruments and automation equipment, non-contact detection of metal targets. Zhuoxin provides customers with innovative inductive proximity sensors to meet the needs of the automation and process control market within its scope. We have many years of rich experience and flexible work in this field. The product characteristics of Nanchang inductive sensors are:; Smooth or threaded stainless steel cylindrical shell; Reverse polarity protection and short circuit protection LE status indication; M8, M12 connector connection or terminal wiring method; PVC, PUR or silicon cable outlet method; 2-wire, 3-wire, 4-wire DC, AC, NAMUR output mode, and AS-I bus output mode; Characteristics of inductive sensors in application scenarios:; Signal output: 4-20; mA  Analog quantity& nbsp; Integrated speed monitor: up to 100; Hz  Cylindrical pressure sensor: high pressure resistance 500; bar  Cylindrical pressure sensor: high pressure resistance 500; Sensors for bar hazardous areas: used for stainless steel sensing surface sensors for dust and dust; Up to IP68/  K sensor (capable of immersion in water/anti pressure water column spraying); In general industrial settings, eddy current proximity switches and capacitive proximity switches are commonly used. Because these two types of proximity switches have higher environmental requirements. When the tested object is a conductive object or an object that can be fixed on a metal object, eddy current proximity switches are generally chosen because of their response frequency, good resistance to environmental interference, wide application range, and wide range. If the measured object is non-metal (or metal), liquid level, powder content, plastic, tobacco, etc. A capacitive proximity switch should be selected. This type of switch has a response frequency but good stability. Environmental factors should be considered during installation. If the measured object is a magnetic material or if magnetic steel is buried inside the measured object to distinguish it from objects moving together, a Hall proximity switch should be used. In environments with good environmental conditions and no dust pollution, photoelectric proximity switches can be used. The photoelectric proximity switch has almost no impact on the measured object during operation. Therefore, it is widely used in demanding machines and tobacco machinery. In anti-theft systems, automatic doors typically use pyroelectric proximity switches, proximity switches, and microwave proximity switches. Sometimes, in order to improve recognition reliability, the above-mentioned proximity switches are often used in combination. Regardless of the type of proximity switch selected, attention should be paid to the requirements for various indicators such as working voltage, load current, response frequency, detection distance, etc. Product model LJ18A3-8-Z/EX, 36VC, two wire normally open, temperature resistant; 200 degree S-level electromagnet TS-250 pull rope switch YM-L2E deviation switch YM-PK2A slip switch; XTD-P      Inductive limit switch model and specification: LJA30-3415ST (SN:=15mm), LXJ-W150 non-contact; Limit switch; BI5-MI8-AP6X-HI141 WAK4-2/POO rope switch LXA-02GKH-T1-A two-stage deviation switch PXA-02GKH-10-30-AEBSP-70 slip switch speed detection switch ESRB-100 0-1852RPM