Zhuoxin

INCHI-CMS/D1B permanent magnet collision safety door device 220V technical parameters: 1. Rated current: 6-15A2, ambient temperature: -20 ℃ -+65 ℃ 3. Relative humidity:< 95% (+25 ℃) 4. Suitable for environments with severe dust, including conductive powder 5. Suitable for places with moderate or below vibration or impact 6. Housing protection level: IP677, rated circuit voltage: 110-380V Usage: Fix the safety door device to the angle steel with M8 screws and wire according to requirements Precautions: 1. This product is equipped with a strong magnetic device inside. Do not keep the watch or phone close to this product for a long time during transportation, installation, and use to avoid magnetization or damage. 2. The accessories of this product (with iron blocks of 3mm or more) need to be made by the user according to the actual situation on site. 3. This product has an indicator light that lights up when the door is opened, the switch is disconnected, and the indicator light is off when the door is closed. The switch is connected. If any abnormalities are found, please refer to the INCHI-CMS/D1A permanent magnet collision safety door device. The permanent magnet safety door lock is a new product designed to address the safety hazards of on-site use of the crane end beam boarding door. It can replace the door bolts and safety switches on the end beam boarding door, and has advantages such as long service life, strong seismic resistance, simple installation, no need to change the electrical control system, and prevention of safety hazards.

The permanent magnet collision safety door device is a high-tech proximity switch with high stability, reliability, and consistency. The working principle is to generate a magnetic field around the sensor through changes in the position and polarity of the trigger, causing the sensor contacts to act. Internally installed strong magnetic device, when the end beam boarding door is close to this product, the strong magnetic device tightly adheres the boarding door to the device and outputs a signal to the electrical control system, playing a synchronous role in locking the door and signal output, making it easier for staff to operate and pass through the end beam boarding door. Using the principle of magnetic induction, the internal switch is activated to achieve the purpose of making and breaking contacts, and to control the external circuit, overcoming the characteristics of poor contact and easy damage caused by mechanical collision switches. This device does not require external power supply, only the red and blue leads can be connected to the translation control circuit. In order to ensure the normal operation of the internal status indicator light of this device, please choose to use it in the correct circuit. Check the cause or replace the product< INCHI-CMS/D1B permanent magnet collision safety door device 220V